当前位置:网站首页>[graduation project 2] intelligent range hood system based on stm32

[graduation project 2] intelligent range hood system based on stm32

2022-06-10 04:06:00 Fourier also has a big head

Tips : Record 2022 year 4 Completed design by month 2

Preface

be based on STM32 Intelligent range hood system , The master controller uses STM32F103C8T6 Core board


One 、 Functional requirements :

  • Design of intelligent range hood based on single chip microcomputer system , Realize intelligent smoke extraction .
  • The smoke sensor can detect the current oil smoke concentration .
  • The fan speed can be adjusted according to the oil smoke concentration .
  • Fire and carbon monoxide prevention alarm is realized through relevant sensors , If the temperature is too high or the concentration of carbon monoxide is too high, give an alarm in time , And on the LCD , Measurement error <=5%.
  • It can be done by APP Control the fan speed , Set the temperature 、 Smoke and carbon monoxide concentration alarm threshold .APP Show the temperature 、 Gas concentration and other relevant information .

Two 、 Code thinking

Turn on timer 2, As the system running time ;
esp8266 Every time 2.5S Refresh once ;
dht11 Every time 1s Refresh once ;
OLED Every time 2s Refresh once ;

3、 ... and 、 Hardware description


  • After system startup , There will be “MyPro” This WiFi, Connect with the mobile network assistant ,

  • ip Address :192.168.1.1 , port 8080

  • Pin connection :

  •         ESP8266:	EN		B0
      					RST		B1
      					RX		B10  
      					TX		B11		
      			
            OLED:      D0    PA5(SCL1)
              			D1    PA7(SDA1)
               			RES   PB7
              			DC    PA4
              			CS    PA6 
      										
      		 fire :       Pick up  pcf8591
      					
      					
      		PCF8591:   SCL2   A0
      					SDA2   A1
      					
      	    smoke :      Connect to PCF8591 On 
      					
      		CO:       Connect to PCF8591 On 
      					
      		DHT11:    from “S” From end to right PB9/3.3V/GND;
    

    • @attention 1、 Provide to ESP8266 The voltage of (3-4v) Or when the current is not enough , Connect wifi Will fail
      2、 The motor must be powered separately
    • The experiment platform :STM32C8T6 Core board

    */

Four 、 Contact for consultation qq:2424644692

Undertaking stm32 Single chip microcomputer 、STC Series MCU design, etc

5、 ... and 、 Code, block diagram and other information

link : https://download.csdn.net/download/qq_43625266/85566512

Like it, please praise it !

 Insert picture description here

原网站

版权声明
本文为[Fourier also has a big head]所创,转载请带上原文链接,感谢
https://yzsam.com/2022/161/202206100400079966.html