[QNX hypervisor 2.2 user manual] 4.5.1 build QNX guest

Write it at the front

It's like building a that runs directly on hardware QNX OS The system is the same , One QNX OS The system can be built as a Guset Use BSP In a QNX Hypervisor Running on the environment .BSP Are architecture specific components .

qmv The configuration will be set to run guest Of VM. in the majority of cases , Construct a QNX guest Just build a bootable image , Just like a non virtualized environment .

Be careful ！

When building QNX Guest when ：

• remember , About to run guest Of VM Must be reviewed guest The expectations of the ： framework , Specific development board , Memory and CPU, Equipment etc. .（ Reference resources “Configuration” Chapter  “Assembling and configuring VMs”）
• Make sure you're guest OS Versions use schema specific guest BSP.（ for example QNX Neutrino 7.1） And the architecture of the development board , Not a specific development board BSP.
• If you do it for you guest Add pass through device , And these devices require a specific development board BSP The driver , You need to copy the driver to BSP Of prebuilt/ The appropriate path under .

One 、 download QNX Guest BSP

You can rush QNX The software center downloads architecture specific QNX guest BSP, for example ：