Jetson nano recording stepping on the pit (it will definitely solve your problem)

Preface

After three days of burning , I finally succeeded , Remember to use the power cord , Don't use data cable , Power cable and data cable are not the same thing ! It's not a thing ! It's not a thing !

One 、 Problems encountered

Come on, guys , Look at the picture directly

This is the first problem encountered , Has the first step been formatted , Then see if your card is NTFS type , See if you are connected USB3.0 On , If you don't receive usb3.0 On , In this way, it can be basically solved , If you haven't solved it yet , Inquiry merchant , Is it written SD card , This image is U Disk image or SD Card image .
That's why I , Then I asked the merchants , He gave me a new image , There was another problem

By this time , I really split , Not yet. , Then I used u Disk burning mirror , Finally, the burning succeeded

When you see the verification interface , It means that you have succeeded , Then it's waiting

Now it works , I am full of joy to boot , But an NVIDIA interface flashed , Then no signal is displayed , It's quite broken , Later, I found the problem again , Never turn on , Then tonight , I took my wire to debug the manipulator , I pulled the power cord of a mobile phone , And then plug in , He switched on , He finally switched on .
Bear in mind , If you have no problem burning , Change the power cord , Usable wire ,LED It will always be on , Look at you led If the light is on for a while, he will go out , Explain that your line can't be used , At this time, just change a thread