Dls-42/6-4 dc110v double position relay

name ： Large capacity two position modular relay

model ：DLS-44/4-4 Two position relay

Rated voltage ：48,110,220VDC/110,220,380VAC

Contact capacity ：250V10A

Coil power ：3.5WDC/15WAC

Action time ：30/25MS

DLS-42

Series models ：

DLS-41/10-2 Two position relay ;

DLS-41/9-3 Two position relay ;

DLS-41/8-4 Two position relay ;

DLS-41/6-6 Two position relay ;

DLS-42/9-1 Two position relay ;

DLS-42/8-2 Two position relay ;

DLS-42/7-3 Two position relay ;

DLS-42/6-4 Two position relay ;

DLS-42/5-5 Two position relay ;

DLS-43/9-1 Two position relay ;

DLS-43/8-2 Two position relay ;

DLS-43/7-3 Two position relay ;

DLS-43/6-4 Two position relay ;

DLS-43/5-5 Two position relay ;

DLS-44/8 Two position relay ;

DLS-44/7-1 Two position relay ;

DLS-44/6-2 Two position relay ;

DLS-44/5-3 Two position relay ;

One 、 purpose

DLS-40 Series double position relays are used in various protection and automatic control devices , To achieve the locking effect . among DLS-41、42 Type is used for straight

Flow loop ,DLS-43、44 Type A is used for AC circuit .DLS-41、43 The coil of does not string contacts ,DLS-42、43 Coil string contacts of

Two 、 Main technical parameters

Rated voltage ：DC 220V、110V、48V;AC 220V、110V.

Rated current ：0.25A、0.5A、1A、2A、4A、6A.

Action voltage ： Not greater than the rated voltage 70%.

Action current ： Not greater than rated current .

Power consumption ： DC is not greater than 7W; Communication is not greater than 15VA.

Medium strength

The conductive circuits of the product are connected together between exposed non live metal parts or shells , And between the coil circuit and the contact circuit , Should be able to bear

suffer 2kV( Valid values ),50Hz Of

AC test voltage duration 1min Test of , Without insulation breakdown or flashover .

DLS-42/6-4 DC110V Two position relay

Ordering instructions

The relay model and specification must be indicated when ordering Structural form code Wiring mode before or after the board .

“ Two coils , Each coil is connected with a contact in series , One normally open and one normally closed , The force exerted by a magnet when there is no electricity , Fix the armature in the initial position , When the coil of normally closed contact station is powered on , When the coil is energized, the armature moves , After the action, the magnet will fix it at the position after the action , At the same time, the armature acts to make the series connection point of the two coils Set switch , The original normally closed contact is open , De energize the coil , The original normally open contact is closed , At the corresponding coil Ready to power on . Because it is held mechanically by a magnet , Therefore, after the control power supply disappears, its position will remain in the control position The state before the power supply disappears , It will not return to the original state after power loss like the electric hold relay .”

Shanghai Joseph relay business department