Lesson 8: FTP server setup and loading

2.6 FTP Server Setting and loading

Use VxWorks Of BootRom After booting the target board , The target board is in BootRom Under control . This is the time , Users need to go through BootRom Prompt for simple configuration , To load and run VxWorks System image .

VxWorks There are many ways to load system images , Including network loading 、 The simulator loads 、SD Card load 、NorFlash load (tffs File system loading )、SATA Disk loading （DOS File system loading ） etc. , Each loading method is applicable to different scenarios . When VxWorks In the development stage , It needs to be revised over and over again BSP、 Kernel clipping 、 Add a peripheral driver , Then compile and generate VxWorks Load the system image into the target board for debugging , Now load VxWorks The best way to mirror the system to the target board is network loading . To the whole thing VxWorks After the system image function and performance meet the requirements , Before VxWorks The system image is fixed to the board Flash In or on a storage disk , And then through Flash And a storage disk VxWorks System image .

The following chapters will introduce the network in detail FTP Mode load VxWorks System mirror mode .

2.6.1 PC End settings FTP Server

         How to use the Internet FTP load VxWorks The system mirror ? First, open it on the computer FTP Software , This switch can be used directly WorkBench3.3 In the environment wftpd32.exe Software , Here's the picture ,wftpd32.exe The path where the software is located is WindRiver6.9.4.9\vxworks-6.9\host\x86-win32\bin.