Read and upgrade st-link chip information and SWD burning media through STM32 stlink utility tool

adopt STM32 stlink utility Tool pair ST-LINK Read and upgrade chip information and SWD Burning media

Yes ST-LINK Of the burner SN Sequence and firmware version reading

Program burning

similar STC-ISP software function

1. Load the burning program
   
2. Click start burning program
   

• Burn information
  

Yes ST-LINK Upgrade the firmware version of the burner

It can be solved in the process of daily use , If you can't recognize and burn the program suddenly , Can pass STM32 stlink utility Tools , Refresh or upgrade the firmware of the burner , In order to solve the failure of normal use caused by the lack of burner program .

 This is for ST-LINK Upgrade features , Can solve ST-LINK Generally unrecognized and downloaded faults during use .

The general failure here cannot be identified ： finger ST-LINK After the burner is connected to the computer , stay Keil The software interface cannot be found ST-LINK The failure of the sequence leads to the failure that the program cannot be burned normally .

• Operation method and steps
  

• Click Connect device （st-link）

• Click on Yes Upgrade process
  
• Upgrade success
  

About more about STM32 ST-LINK utility For usage information, please refer to the help manual of this software , Read and research （PDF The total number of documents is 54 page ）