当前位置:网站首页>How to lay copper in AD (aluminum designer)

How to lay copper in AD (aluminum designer)

2022-06-13 04:44:00 Look at the mountains_ Lau

stay PCB.PcbDoc In file :
Under software, select "Top Layer ( top floor )"
(1) perform " place "->“ Copper laying ”; Or shortcut key " PG ". Will pop up "Properties ( attribute )" panel .

(2) stay "Properties ( attribute )“ panel ,Net ( The Internet ) choice GND; choice “ Reticular copper ” or “ Solid copper ”; Choose "Remove Dead Copper( Delete the isolated copper laying )”, Other defaults are ok .

(3) The cursor changes to a cross , Prepare to start copper laying operation ;

(4) Follow with the cursor PCB Of "Keep-Out ( No wiring layers )" The boundary line draws a closed rectangle . The single machine determines the starting point , Move to the single machine at the inflection point , Until... Of the rectangular box is determined 4 vertices , Right click to exit . then Right click and double click to confirm copper laying .
The user does not have to manually close the rectangle , The software will automatically connect the start point and the end point to form a closed frame .

(5) thus , The software generated "Top Layer ( top floor )" Of copper

(6) choice "Bottom Layer ( Bottom )", repeat 1-4 The operation of , Lay copper on the bottom layer .

Welcome to your attention , WeChat official account
 Insert picture description here

原网站

版权声明
本文为[Look at the mountains_ Lau]所创,转载请带上原文链接,感谢
https://yzsam.com/2022/02/202202280521129625.html