How ZABBIX 5.0 adds esxi6.7 to monitoring

zabbix 5.0 How to integrate esxi6.7 Add to monitor

There's a need today , Need to put one esxi 6.7 server Add to our zabbix On the monitoring server , Write down the pit I stepped on in the operation

To configure

Before configuration , We need to modify zabbix server The configuration file /etc/zabbix/zabbix_server.conf, Enable StartVMwareCollectors Parameters , It is not enabled by default . I only set the value here to 2, Because I only need to monitor one esxi The server , If there were more monitoring numbers , You can refer to this servicenum < StartVMwareCollectors < (servicenum * 2) To set up .

After modification , restart zabbix-server service

systemctl restart zabbix-server

Then we need to be in esxi Enable the debugging function in , stay esxi Advanced settings for host management can be found Config.HostAgent.plugins.solo.enableMob, Default false It is amended as follows true, As shown in the figure below

After the save , You also need to add an independent read-only user to make zabbix obtain esxi Parameters

Give permission after adding ( host --> operation --> jurisdiction )

When the configuration is complete , We need to open it https:///mob/?moid=ha-host&doPath=hardware.systemInfo Check the host's uuid

After completion , We can start at zabbix The host is added to the , The host name here must be UUID

Then add the macro , Here's a problem to pay attention to , because 5.0 Changes , The macro value is now

、{VMWARE.USERNAME}、{VMWARE.PASSWORD}、

• {$VMWARE.URL}： Fill in here https://<esxi_ip>/sdk
• {$VMWARE.USERNAME}： Created esxi user
• {$VMWARE.PASSWORD}： Create user's password
• {$VMWARE.HV.UUID}：esxi Of uuid