The solution to the error "xxx.pri has modification time XXXX s in the futrue" in the compilation of domestic Kirin QT

If the article is original , Reprint please indicate the source of the original
This article blog address ：https://hpzwl.blog.csdn.net/article/details/125235915

Red fat man ( Red Imitation ) The complete blog of ： Development technology collection （ contain Qt Practical technology 、 Raspberry pie 、 The three dimensional 、OpenCV、OpenGL、ffmpeg、OSG、 Single chip microcomputer 、 The combination of software and hardware and so on ） Ongoing update …（ Click on the portal ）

Qt Development column ： All kinds of problems are solved ( Click on the portal ）

Related development of domestic Kirin system

problem

   Domestic Kirin system installation Qt Report a mistake later “xx.pri has modification time xxxx s in the futrue”, Pictured ：
  

reason

  config.pri The modification time of the file is greater than the current system time , During installation, the system time may not be synchronized with the network, and it may be greater than the current actual time , And then installed Qt（ Otherwise, we need ” land “）, After installed , Re networking calibration time , That's the problem .

resolvent

   Uninstall directly , It's faster to reload （ Tried to modify the update time directly , The test is invalid ）.

If the article is original , Reprint please indicate the source of the original
This article blog address ：https://hpzwl.blog.csdn.net/article/details/125235915