[cadence Allegro PCB design] error: possible pin type conflict gnd/vcc power connected to output

        cadence The schematic diagram is running DRC Times wrong , The error information is as follows .

[cadence-DRC]error: Possible pin type conflict GND/VCC  Power Connected to Output

resolvent :

         First step 、 function DRC Find and analyze the source of the error

         function DRC, Output the above ERROR after , The green circle is ERROR, Click to display the error message . We can see the green error reporting circle page , Clicking on the pin attribute is connected to the pin attribute output above （OUTPUT Property will produce the previous page VCC This causes the device to share one VCC The Internet ）, But normally, pin attributes are passive/power. therefore , We manually change the properties of the device pin to normal .

         The second step 、【edit part】 Change to Power attribute

         Select the power supply component , Right click selection 【edit part】, Enter pin modification in schematic library mode （ If you do not change the pin attribute in this mode, you cannot operate ）, take Output Change to Power attribute ( or passive)

         The third step 、 Run again DRC, Problem solving ~