Steps to configure V530 switch

1. attachment

among , The interface of the two wires is shown in the figure below

2. download Xshell Software

In the notebook , Download and install Xshell Software , See this link for detailed steps ：Xshell Download and install

3. Installation driver

If in the device manager , There are the following problems , The driver needs to be installed .

After installation, you can see the above... In the device manager “ft232r usb uart ” disappear , And the port appears COM The words...

The download website is ：
Driver download tutorial
Or download it from the following Baidu online link .
link : https://pan.baidu.com/s/1LaYvknQgOVTrj90DKzdgrg
Extraction code : bhdw

4. Link switch

The connection configuration is shown below ：Xshell Connect a router or switch Console mouth

The baud rate should be configured as 115200, It can't be 9600, otherwise , Input will be garbled

Random code shows ：

Correct display ：

5. Some common sense

The network port on the upper left side of the switch （Console mouth ） It is used to configure the switch , The lower mesh port （eth mouth ） It is the network port of the switch itself , All other ports are used to provide switching .

6. Common commands

Thank you Hongwei 、 Yongjia 、 Jiang Yu's technical help ！