1.44 inch TFT-LCD display screen mold taking tutorial

Catalog

1. software package ： Click to download

 2.LCD_ASCLL Code modulo tutorial

 3.LCD Chinese character modeling tutorial

 4.LCD Picture modeling tutorial

---

1. software package ： Click to download

 

 2.LCD_ASCLL Code modulo tutorial

(1). Open the mold taking software

 (2). Select character mode in the upper left corner

 (3). Click the options

 (4). Set as follows , Then click OK

notes ： The number of dot matrix to be selected should be greater than the number of bytes occupied by characters , for example 8x16 The bytes occupied by the characters of are

8x16/2=16, So the lattice here is larger than 16 Just go .

 (5). With 8x16ASCII Take the mold as an example ：

Word width and word height are changed to 16, So the corresponding ASCII Code for 8x16, The width of the word will be half of the original

Then type in the input field ASCII clock

 !"#$%&'()*+,-./0123456789:;<=>[email protected][\]^_`abcdefghijklmnopqrstuvwxyz{|}~

  Click generate font

The generated font is as follows

 8x16 The font is in the routine lcdfont.h It has been taken from   As shown below

 3.LCD Chinese character modeling tutorial

(1) Open the mold taking software

(2) Select character mode in the upper left corner

(3) Click the options

(4) Set as follows , Then click OK

 (5) With 16x16 Take the mold of Chinese characters as an example ： Word width and word height are changed to 16

  Then input Chinese characters in the input field

Click generate font

The generated font is as follows

 

Then copy the font to the routine lcdfont.h Folder In the following array

notes ： You need to add this Chinese character before the font of each character , And enclose it in double quotation marks and then add a comma ！

  4.LCD Picture modeling tutorial

Open the software in the folder below

 

 (1) Open the picture to be molded ： In the form of a routine 40x40 Take Penguin pictures for example

 (2) Observe the input image in the lower left corner , If the display is as follows , Please have a look at (3)

  If an invalid input image is displayed , Then please use the drawing software that comes with your computer to convert the pictures into 16 Chromatic bmp Format picture .

(3) After opening the picture Set as follows

Output data type ：

                                                 Scanning mode

  Output grayscale

  stay 16 The color data of bit color is arranged as ： Red green   Blue

  Maximum width and height

  Click... After setting

  Be careful ： This software can only reduce the picture, not enlarge the picture ！ Scaling down is equal scaling down ！

Then look at the lower right corner

This output image is the size of the actually generated image

  In this section, check the high order first

  Then click save , Then copy the generated array to the routine pic.h In the file

  The complete interface is as follows ：