EN 1155 building hardware swing door opener - CE certification

Building hardware swing door CE authentication （ EU compulsory certification ）－ brief introduction

In the EU market “CE” The mark is a compulsory certification mark , To show that the product complies with the EU 《 New methods of technical coordination and Standardization 》 The basic requirements of the directive . This is a mandatory requirement of EU law on products .

Stick on the swing door of building hardware CE The logo can not only prove that its products comply with the building products directive （CPR 305/2011/EU） And related standards （ Harmonized European standards EN 1155） Prescribed safety , Environmental protection , Health and consumer protection . And it can reasonably avoid technical barriers to trade , Sell freely in the European market and open up other international markets .

notes ： EU building regulations CPR（Construction Product Regulation） 305/2011/EU Fully replace the EU construction products directive CPD(Construction Product Directive) 106/89/EEC, And from 2013 year 7 month 1 Enforcement from

EN 1155 The standard name of swing door of building hardware is ：

EN 1155 Building hardware - Electrically powered hold-open devices for swing doors - Requirements and test methods

EN 1155 Building hardware . The swing door uses an electric hold open device . Requirements and test methods

Want to get building hardware CE Certification requires compliance with the product directive ： Building product regulations CPR(Construction Product Regulation) 305/2011/EU, as well as , Harmonized European standards ：EN 1155

EN 1155 Building hardware swing door CE The product range involved in the certification ：

This European standard specifies for fire protection / Independent hold open device on smoke isolation door , And the requirements of keeping the opening mechanism combined with the door closer . Electric spring door hold open device manufactured according to this standard , The spring door can be kept in a fixed position or allowed to swing freely . In each case , The interruption of power supply will close the front of the controlled door .

It is recommended that electric hold open devices manufactured in accordance with this European standard , Used for self closing fire protection that requires reliable opening and release / Where the smoke door assembly is located .

Although these devices can contain smoke or fire detection elements , However, the performance of these specific elements is not within the scope of this European standard .

The door closing device is controlled by en1154 Cover .

EN 54 Series of European standards cover resettable smoke / Requirements for fire detectors 、 Test methods and Performance Standards .

Building hardware swing door CE authentication － The certification process ：

1、 Determine the type of product to be certified , Application for submission

2、 Determine the European product directive , Building hardware must comply with the new EU building products regulations CPR 305/2011/EU

3、 Determination of harmonized European standards , Building hardware shall comply with coordinated Standards EN 1155

4、 according to CPR Directives and harmonized standards EN 1155 Test and evaluate , EU notified certification bodies according to the certification system 3 Conduct test certification

5、 Obtain test reports and certificates issued by EU notified bodies

6、 Issue product performance statement (Declaration of Performance)

7、 The product package is pasted with the code of the notified body CE sign

8、 Sell freely in the European market

come from JJ2022