Use of SAP QM inspection points

SAP QM Inspection point (Inspection Point) Use

The author's K On the project , Yes, it's enabled inspection point The function of . I write this article here , The checkpoint function is recorded in K Several key areas of how to use on the project .

1） In inspection plan Header A checkpoint is assigned to the 200.

2） Inspection point 200 yes SAP A standard value predefined by the system .

Inspection points are defined in the following places ,

see 200 The detailed data of this checkpoint ,

3） Inspection points in the result entry interface .

4） Use the checkpoints of the decision interface .

Because the inspection point on this inspection lot is Physical Sample, So there are more on the interface ”Phys.samples” Tab for , Pictured above .

- End -

Written in 2021-7-18.