LM small programmable controller software (based on CoDeSys) note 19: errors do not match the profile of the target

Wrote a program , Ready to upload to plc Go inside , As a result, I couldn't log in , Report a mistake ： 

  It was found that the project was set incorrectly when it was created , It can be changed here

Just change the configuration to this one here

Click... In the main interface “ file ”/“ newly build ” menu , Or click... In the toolbar “” Button , And then there comes “ Goal setting ”

Dialog box .“ The goal is ” Refer to PLC Storage space , Target setting is based on the selected PLC Of storage space .

stay “ To configure ” Column “HOLLiAS-LEC G3 CPU Extend”, This target is that the program storage space is 120KB Of CPU

Selected settings . Click on “ confirm ” Button , Pictured 7-1-1 Shown .

If the module used is storage space 28KB Of CPU, You need to select “HOLLiAS-LEC G3 CPU”. If you're not sure

Program storage space size of the module , Please see Appendix

​​​​​​​