0816 shortcomings of Feida (improvement direction)

0816 Open source Feida official website ：https://docs.mgrl.de/maschine:pickandplace:feeder:0816feeder

All parts of this Feida are open source , Capable friends can reproduce themselves completely .

        1. This Feida material package is ready-made , The structure is made of 3D The printer prints it by itself . A total of 10 Material packages , A steering gear was burnt out during debugging （ The reason is that the pushing needle is blocked , The steering gear is always locked , Then it burned ...）

       2. If this Feida is a push 0603,0805,1206 The effect of the material is very good , coordination JUKI 504 Suction nozzle of , It can achieve neat mounting effect . But push 0402 Words , Due to printing accuracy and steering accuracy , The actual use is not very stable .

       3. And the Feida is pushing 0603 For some braiding （0402 and 0603 Most of them are paper braided belts ）, Because the braid is thick , because 3D Printing accuracy , This causes errors in the braiding groove , As a result, it will be difficult to push the braided belt , In this case, it is easy to burn out the steering gear . The solution is to take apart the Feida , Scrape the braiding groove with a small flat screwdriver , Know how to push smoothly 0603 Woven belt .0805 1206, Due to its thick thickness , The tape is made of plastic , So the edge of the braid is very thin , There won't be this problem .

      4. There's another problem , The winder is far from the front , Every time we rewind the tape, we will waste some materials ....