Delta controller rmc200

This article introduces DELTA Electro hydraulic motion controller .DELTA controller RMC200 Can be controlled 32 Axes , With what we know well RMCTools It can be easily synchronized , From simple control of single loop to pressure of double closed loop / Complex control of force .

chart / writing Thinking about the fluid He Jing

DELTA Put the existing RMC200 The number of shafts on ranges from 32 Add to 50 individual , To control the application RMC200 B15 The maximum number of physical axes of the basic module .DELTA Then a new RMC200Lite controller , The controller can realize 18 Axis control , And equipped with a new CPU/ Power module , as well as B5L、B7L Basic modules . Finally, the minimum cycle scanning time is changed from 250μs Shorten to 125μs, Thus, the rapid response system has faster response control .

These improvements provide industrial users , Best for its application RMC Flexibility of motion controller , And will be cost-effective RMC200 Lite At most 18 Application of shaft , RMC200 The standard is still up to 50 Greater flexibility in shaft applications , Or ask for more processing capacity . Because of new Lite Controllers and all RMC The controller shares the same RMCTools Software , And the supported functions are consistent with the standard , Therefore, users can easily accept new Lite controller .

more DELTA controller RMC200 Please pay attention to Sicheng fluid .