Stm32 cubemx hal----- PWM - change frequency

LED1–3
Key1–5

Output PWM Waveform time , Use 2 Patterns ：
sConfigOC.OCMode = TIM_OCMODE_PWM1;
sConfigOC.OCMode = TIM_OCMODE_TOGGLE;

They correspond to cubeMX in

The following changes are made in the program CCRx：
__HAL_TIM_SET_COMPARE(&htim5,TIM_CHANNEL_1,(uint16_t)CCRTemp);
__HAL_TIM_SET_COMPARE(&htim5,TIM_CHANNEL_2,(uint16_t)CCRTemp);

Through the actual output waveform, you can see ：
1. change CCRx after , The frequency of both modes will not change , The frequency depends on PSC, ARR, And CCRx irrelevant ;
2. change CCRx Yes TIM_OCMODE_TOGGLE No influence , Its frequency remains unchanged , The duty cycle is always 50%
3. change CCRx Yes TIM_OCMODE_PWM1 Had an impact , Its frequency remains unchanged , The duty cycle changes .