The solution of displaying garbled code in SecureCRT

Find the problem

stay Ubuntu Code in , The output sentence has Chinese , such as "printf(" What you read is ：%s.\n", buf);". Use cross compilation tool chain to compile , Transfer the executable program to the development board system to run , And use SCRT To observe the test results . At this time, it is found that the Chinese output will be garbled .

To analyze problems

Linux The default character code of the system is UTF-8 Format , To put SecureCRT Also set to UTF-8 To display normally .

solve the problem

1、 Select the character encoding as UTF-8

Click on Options --> choice Session Options --> Click on Appearance. Set the character encoding to UTF-8 Format .

 

2、 Set the character set to GB2312

If only the character encoding is set to UTF-8, The character set is not set to GB2312, Then the displayed characters are question marks ！

Click on Font .. --> Set the character set to GB2312.

3、 Disconnection and reconnection

After setting up , Disconnect again SecureCTR And Linux The connection of the system , Just reconnect .