Parker driver maintenance COMPAX controller maintenance cpx0200h

COMPAX controller ： Controlled by different analog power signals , from MOSFET IC Level drive GND/PGND（ Power grounding ）） Signal control , Should be grounded separately . Use IC Control of small signal part of IC,SGND Connection point between signal and power ground . The reasonable method is to return the ground signal to a ground point of the power layer . It is necessary to connect a ground point under the ground wire , The ground connection can be realized .

Compax 3 Debugging steps ：

One Software installation

1 Servo driver setting software

2 PLC Programming software

3 CAM Edit software

4 install PLC Library files of software

5 Install help files

 

Two Drive connection

1 Control power port X4

2 Motor power line port X3

3 Drive main power port X1

4 Braking resistance 、 Bus port X2

5 Communication port X10

6 Motor feedback port X13

7 Analog quantity 、 Encoder port X11

8 Digital quantity port X12

3、 ... and Servo driver parameter setting

1 Connect the servo driver

2 Set servo communication parameters

3 Set drive parameters （ Test drive ; Drive parameter settings ; Parameter optimization ; Check the parameters ; Commissioning mode ; Load self-tuning ; Oscilloscope ; Parameters change ; Look at the history of errors ; I/O simulation ; Save parameters and upload parameters ）

Four PLC Programming and debugging

1 Programming

2 Program debugging

5、 ... and CAM   11 Software installation software installation

Servo driver setting software servo driver setting software Servo driver setting software servo driver setting software install SETUP-ParkerIntegratedEngineeringTool-C3MGR2plugin-V2 Or higher .