Solution of adding st-link to Huada MCU Keil

Use st-link+keil Download and debug the tutorial of Huada MCU
Let's start with , So far, only HC32F005, But theoretically, this method is universal

One 、 Download support package
Find your chip information page on the official website of Huada , download DDL Library zip and IDE Support package , That is, the two compressed packets .

 

Decompress separately , double-click IDE Support the... In the package MDK_IDE Directory support package installation .

Two 、 add to flash Model
1, Copy file
open DDL The library folder , find mcu\MDK\config In the path FLM Postfix file , Copy to your keil Installation directory ARM\Flash Folder .

2, Configuration Engineering
open DDL The library folder , Open any one of example Projects in the catalog , The first one I choose here example\adc\adc_cont_irq_sw\MDK

Point magic wand configuration project

find Debug tab , Select the debugger you use , I am here ST-Link, Then click Settings Set it up

Switch to Flash Download tab , spot Add add to

  You can see the file just copied , Click Add to

After that , You can download and debug happily