Easycvr invokes the interface parameter acquisition method and precautions of device video recording on the page

Recently, with the users and netizens on EasyCVR Increased attention from , about EasyCVR The internal interface is also the focus of the consultation , For problems that users pay more attention to , For example, the interface problem of calling device video recording , We also attach great importance to . This article will share with you EasyCVR Problems needing attention in calling device video recording .

The above interface is EasyCVR Interface for obtaining the address of the device video playback stream , A total of four required parameters and one optional parameter are required to call this interface , Let's talk about how to obtain parameters .

Parameters Channel It's the tunnel id You can get it from the interface in the figure below ：

Parameters File It is a parameter that users consult more , There is no introduction to obtaining this parameter in the interface document , However, the file name can be obtained through the following interface ：

Get name after , You can bring in file In the parameters ：

In addition to these two parameters that need to be obtained , The other three parameters need to be defined by the user , among stime and etime The format of is mainly YYMMDDHHmmss The format of .

After the configuration is completed, you can obtain the equipment video you need .

There is another point that we should pay attention to ,/api/v1/devices/stopchannelstream This interface is not available in the interface document , If you need to call this interface , It can be called on the browser .