The solution of "no startup device" after running Bochs

And then what just happened bochs Exploration

Just now there was this prompt ,BIOS say “ No boot device

We can type in bximage --help View help for command

as follows

usage The following is what we need to input . I have tested this method , But it is very inconvenient , We can choose to input numbers bximage enter , Then there is a series of tips , Just make your choice , Pictured ：

  This is the first time I did it , I found that there was already a man named “hd60M.img" The hard disk of , So in the last step, I chose “no”, So I just quit . But not in a hurry , Let's just do it again .

  This time I changed my name to a new one “hd60M2.img"

And then bochs Directly write the hard disk configuration for us ！ It is obvious that you have worked hard . All we have to do is follow the prompts , hold

These are copied into our bochsrc.disk in , And in “ Hard disk settings ” Add... To that column

 

  My display is “ Setting up the hard disk ”, The second line is the statement that the system I added asked us to add .

I can't wait to see bochs Operating condition , But every time it starts bochs Always cd cd cd cd until cd To bochs Under the bin Catalog , Then input bochs To open , This is a little troublesome . After collecting information on the Internet, I found that it actually started bochs There is a simpler way to do this , That's using -f To specify its configuration file .

bin/bochs -f bochsrc.disk

enter , Observe the effect , As shown in the figure

 

 

It looks like an error , But the reasons are different . One is boot failed:could not read the boot disk  The other is boot failed:not a bootable disk, This is not a boot disk . The two reasons are obviously not the same , It's like a dress that doesn't fit , The reason is that a person is too fat , The other man is too thin . Let's not lose heart , I will continue to study , Continue to update ！