How to set packet capturing mobile terminal

1. adopt charles Realize packet capture

First of all confirm Charles Whether the proxy settings of are correct ： Steps are as follows ：

First step ：

The second step ：
Then set it on the mobile terminal

The server can be based on win+r+cmd, Input “ipconfig” obtain ; The port is the following Charles Same port ;
The third step ：
stay Charles Whether to allow the pop-up on the end, and then select allow to succeed ;
2. adopt fiddler
open Fiddler, Configuration parameters ：　　
First step ：
To configure fiddler Allow listening to https, open Fiddler A menu item Tools->Options->HTTPS, Check CaptureHTTPS CONNECTs, Click on Actions, Check Decrypt HTTPS traffic and Ignore servercertificate errors two , Click on OK（ The first click will pop up whether to trust fiddler Certificates and security tips , Just click yes Just go ）, See the picture ：

The second step ： To configure fiddler Allow remote connections
Click on Tools->Options->Connections, Check allow remote computers to connect, The default listening port is 8888（ The figure below Fiddler listens on 　　　 port It's the port number ）, If the port is occupied, it can be set to other , Restart after configuration fiddler, Here's the picture ：

　　 Important note ： After opening the remote connection , restart Fiddler, Otherwise, the remote configuration you just started will not be updated
The third step ： Configure the parameters of the mobile terminal
First of all, make sure that the mobile phone and computer are on the same network ; Then you need to know the of the computer ip Address computer ip The address is available through cmd, Input ipconfig Inquire about , Besides, you know fiddler Port number ,Tools->Options->Connections,port The median value is the port number , The general default is 8888; Next, start operating the mobile phone ; And Charles The steps of operating the mobile phone are the same .