PCB frame drawing - ad19

pcb Of course, the drawing of board and frame should be switched to keep out Layer

Find settings , find keep out
Suppose we want to draw a rectangular plate frame , We can choose the wire diameter

Manually draw a rectangular frame
We need to define our board borders according to the lines we draw . Remember to select the border we draw first （ Select the whole box and then click design to find “ Define by the selected object ”）


That's it , We can switch to 3d Check the effect
Press the number key 3 that will do , Back to press 2

We can also place 4 A fixing hole

I choose 3mm For pad 3mm The hole is also set to 3mm


First, draw a reference line in the lower left corner. We can align the center of the fixed hole with the intersection of the reference line , After adjusting the position of the fixing hole , You can delete the drawn reference line .

We select the target and press m key , Move it to the specified position



Like above , Remember to delete the reference line .
rest 3 Two fixing holes can be used ctrl+c Then select the reference point and finally Ctrl+V To achieve , You can use spaces to adjust the direction

The above is only a record without communication