The method of SolidWorks modifying text font in engineering drawing

   The engineering drawing of the graduation project was pointed out by the teacher that the font size of the annotation was wrong during the graduation defense , So I went back to study the requirements of annotation fonts in engineering drawings . My engineering drawing uses SolidWorks Software drawn , Let's record it SolidWorks How to modify the text font in engineering drawing by software .

Modify dimension font

The font of the annotation is shown in the red box in the following figure ：

Modify the font of a dimension separately

1. Click the dimension of the dimension , Make it blue selectable , Switch to on the left other tab , As shown in the red box in the figure , Use document Fonts It's the tick status , This means that the font of the dimension is displayed according to the default font set in the document , So if you want to change the dimension of this dimension alone , First of all, you need to uncheck Use document Fonts
   

2. Uncheck the Use document Fonts Then click... In the red box below typeface Button ：
   

3. You can modify the font settings of this annotation in the pop-up window , The standard specifies that the font is Han Yi Long imitation song style , General choice routine style , The font height is generally 3.5mm, There are other 5mm、7mm、10mm、14mm、20mm etc. , If you need to increase , Then press √2 Multiple increase , This time, the word height is changed here 10mm The font of ：
   

4. This is the result of the change 10mm The style of word height （ It's just a demonstration , Normal word height 3.5mm that will do ）（ Note that only one annotation font is modified here , So the other 50 The font for dimensioning is unchanged ）：
   

Change the font of all dimensions

1. It can be seen from the above that the font of a single annotation is modified , The font of the annotation is the font template set in this file by default , So you want to change the font of all dimensions , You need to modify the font template of the file . Open the settings button （ Click on the gear ）：
   
2. First click on document properties , Then click on the dimension , Finally, click font ：
   
3. The operation method here is the same as that in the previous step , For example, it is revised to 7mm A tall font ：
4. Here is to modify the font of all annotations , So two 50 The font for dimensioning has changed ：
   

Modify annotation font

1. Modifying the annotation font is easier , When adding notes, you can directly modify the red box in the figure ：
   

That's all of this , Welcome to leave a message in the comment area to discuss with each other , We also welcome criticism and correction ^ _ ^