Related configuration commands of Huawei LACP

interface eth-trunk x ： Create aggregation port
（ Aggregate port view ：）trunkport inter g0/0/1 ： Add an interface to the aggregation port
（ Aggregate port view ：）mode lacp/manual ： Modify the mode of the aggregate port
（ Interface view ：）eth-trunk 1 ： Add this interface to the aggregation port trunk1 in

Aggregate port view ：mixed-rate link enable ： Set the aggregation port to include ports with different rates
In the system view ：lacp priority x : Configure the priority of the aggregation port
Interface view ：lacp priority x ： Configure the priority of the interface , Only interfaces that have been added to the aggregation group can be configured
mac-active-linknumber x ： Configure the maximum number of active interfaces
least-activ-linknumber x ： Configure the minimum number of active interfaces
load-balance xxx ： Select the load balancing mode , The load modes that can be selected are shown in the following figure ：