Win10 system OmniPeek wireless packet capturing network card driver failed to install due to digital signature problem solution

1、 Precautions for installing the drive

1）win10 The problem of system digital signature leads to the problem of installation failure resolvent

• close secure boot 

Get into bios->Boot->Secure Boot-> Set to Disabled（ Some computers are in Security Set in the ）

Save and restart the computer

notes ：

secure boot Purpose
secure boot The scheme adopts signature authentication for the system software , The operating system of the equipment before leaving the factory Image The document is signed and authenticated , And put the Hash The value is written into the one-time programmable module of the chip .

2、Win10 Disable driver forced signing

Input cmd-> Run in administrator mode ->bcdedit.exe /set nointegritychecks on （ close ）

notes ： Input cmd-> Run in administrator mode ->bcdedit.exe /set nointegritychecks off（ Turn on ）

3、 Install driver

Restart the computer after installation

4、 Open software

notes ： Need to run as Administrator