SolidWorks simulation curve attribute setting

1、 Remove the 2 A gray line method （ Here's the picture ）

2、 Modify curve width （ Here's the picture ）

3、 Remove the real-time position display method shown in the figure below （ Below ）

4、 Modify the graph Title （ Here's the picture ）

5、 Modify the ordinate Title （ Here's the picture ）

6、 Change the ordinate from 1 Change to the set value （ Here's the picture ）, Be careful , The change cannot take effect immediately , You need to switch windows before it takes effect

7、 Remove the bottom legend （ Here's the picture ）

8、 Adjust the scale size

9、 Adjust the size of the axis name