How to configure flymcu (STM32 serial port download software) is shown in super detail

in total 4 Step , Super simple

1. Search the serial port of the development board connected to the computer

bsp The baud rate cannot exceed 76800

 

2. Select download program

3. Click on STMISP Interface , stay （1） check （2） Execute after programming Check these two options

4. The bottom choice DTR Low level reset ,RST High level feed BootLoader( The fourth option from top to bottom )

  Other options default , Click start programming .

If there is a mistake , Welcome private message ！

I hope it will help you who are working hard ！