AutoCAD - lengthening

Used to change the length of the object and the included angle of the arc , You can specify its change as a percentage , Increment or final length or angle .

Way of execution

（1） Click the menu bar “ modify → Lengthen ”. Pictured ：

（2） Enter... On the command line “LENGTHEN” Press enter key . Pictured ：

Operation steps

After executing the command , The command line displays the following information ;

Option description

（1） The incremental ： Change the length or angle of the object by specifying the amount of increase .

Length increment

Angle increment

（2） percentage ： Change the length or arc of the object by specifying a percentage of the total length .

（3） All ： Change the length or angle of the object by specifying a new total length or angle value .

Total length

Total angle

（4） dynamic ： In this mode , You can use the method of dragging the mouse to dynamically change the length or angle of the object .

The drawing effect of the lengthening command is as follows ：