Visual studio 2019 software installation package and installation tutorial

Visual Studio 2019 Software introduction ：

Microsoft Visual Studio 2019( abbreviation VS) It's Microsoft's development kit series products .VS It's a basically complete set of development tools , It includes most of the tools needed throughout the software lifecycle , Such as UML Tools 、 Code control tools 、 Integrated development environment (IDE) wait .

Visual Studio 2019 Software download ：

[ Full name of software ]：Visual Studio 2019

[ Software size ]：1MB

[ Software language ]： chinese

[ Installation environment ]：Win7/Win8/Win10/Win11​

[ Pre installation work ]： During the installation process, the network must be disconnected and the anti-virus software must be closed , Otherwise, the installation will fail .

Visual Studio 2019 Software installation tutorial ：

1. Open the downloaded software installation package , Right click the compressed package and select 【 Unzip to Visual Studio 2019】.

2. Open it and unzip it 【Visual Studio 2019】 Folder .

3. Right mouse click 【vs_Professional】 Erection sequence , choice 【 Run as administrator 】.

4. Click on 【 continue 】.

5. Please wait while setup initializes .

6. Check the options shown below .

7. Click on 【 change 】 Set the installation path of the software .

8. Click on 【···】 Set the installation path of the software , Can be divided in C Create a new disk other than disk “VS2017” Folder （ Be careful ： Two folders cannot have the same name ）, After setting the installation path, click 【 install 】.

9. Please wait while the software is installed .

10. After installation , Click the start menu bar in the lower left corner of the desktop , Find and open... In the start menu bar 【VisualStudio 2019】, Hold it down with the mouse 【Visual Studio2019】 Drag the icon to the desktop to create a shortcut .

11. Click on 【 later 】.

12. choice 【 routine 】, And choose the theme according to your preference , Then click on 【 start-up Visual Studio】.

13. Click on 【 Continue without code 】.

14. Click... In the software menu bar 【 help 】, Then choose 【 Registered products 】.

15. Click on 【 Use the product key to obtain a license 】.

16. Enter activation code ：
NYWVH-HT4XC-R2WYW-9Y3CM-X4V3Y, And then click 【 application 】.

17. Show 【 license ： Product key applied 】 Indicates activation successful , Click on 【 close 】.

18. installation is complete , The software opening interface is shown in the figure below .