AutoCAD - continuous annotation

Continuous dimensions are used to produce a series of continuous dimensions , The latter dimension takes the second dimension limit of the previous dimension as its first dimension limit , Applies to linetype dimensions 、 Angular dimension and coordinate dimension .

Way of execution

（1） Click the menu bar “ mark → continuity ”. Pictured ：

（2） Click the annotation toolbar “ continuity ” Button as shown in the figure ：

（3） Enter... On the command line “DIMCONTINUE” Press enter key . Pictured ：

Operation steps

After executing the command , The command line displays the following information ：

Option description

（1） Select dimensions ： Specify linear dimensions 、 Angular or coordinate dimensions .

（2） give up ： Discards the last consecutive dimension entered during the command .

（3） choice ： Select this option , The command returns to selecting continuous dimensions .

The rendering effect of continuous annotation command is as follows ：