The firmware of the connected j-link does not support the following memory access

Installing today J-LINK There is a little problem when driving .

problem ： The computer can recognize J-LINK This drive , however keil Unable to proceed Debug. O 'clock Debug after , The following error appears

 

It is also prompted later dll internal , Turned out to be dll There was a mistake .

resolvent ：

https://blog.csdn.net/razor_et/article/details/81096518

Although this blog post does not explain this mistake , But it's the same as his solution .

 

2、 Problem solving ： resolvent , decompression “Segger.zip” Directly replace the entire directory x:\Keil_v5\ARM\segger.

“Segger.zip” Link to ：

Baidu network disk link : https://pan.baidu.com/s/1rgSt4Ow0QJs54zAHGDaSBA

Extraction code : 8trw
————————————————
Copyright notice ： This paper is about CSDN Blogger 「jinxueH special column 」 The original article of , follow CC 4.0 BY-SA Copyright agreement , For reprint, please attach the original source link and this statement .
Link to the original text ：https://blog.csdn.net/euxnijuoh/article/details/105920552

 

 

First find you install Keil5 The catalog of , find ARM This directory . My catalog is shown below

keil Of JLINK Of dll It's in this directory

 

2. online dll The error is caused by JLINK No updates .

therefore , Just install you JLINK Driven by

 

The three figures below will dll Copy the file to the current MDK segger Under the folder （ You'd better make a backup first , In case of a one thousand .）

Copy finished , Reopen project , compile , download . Be accomplished .

 

(1 Bar message ) install JLINK Drive appears the firmware of the connected J-Link does not support the following memory access_ The embedded _ Wenhong open source studio -CSDN Blog
https://blog.csdn.net/qq_38376586/article/details/84234286