Subject 3 how to turn on the high beam diagram? Is the high beam of section 3 up or down

Subject 3 Diagram of how to turn on the high beam ？ Is the high beam of section 3 up or down

Subject 3 Diagram of how to turn on the high beam ？ Is the high beam of section 3 up or down

Subject 3 lighting simulation test will be tested to low beam 、 high beam 、 And high and low beam lamps are used alternately , The following will introduce how to operate these three , Provide a diagram of how to turn on the low beam of subject three .

1、 The first light control switch

Find the light control lever on the left side of the steering wheel , Turn the knob to the low beam position , You can turn on the low beam , Then pull the lever towards you , Is to turn on the high beam temporarily , When you let go, it will rebound , High beam off , The low beam is still on , This is the alternating use of high and low beams . Push away from yourself , Is to turn on the high beam and keep it on , If you don't understand , Look at the diagram below .

Is the high beam of section 3 up or down ？

Hit up ： Turn on the right turn signal

Hit down ： Turn on the left turn signal

Pull forward ： The high beam lights up once

Push back ： The high beam is on for a long time

high beam

1、 Driving on roads with low visibility , Correct use of high beam .

2、 In sections with poor lighting or no street lights , High beam lamps can be used .

dipped headlight

1、 When turning at the intersection , Use low beam .

2、 When you are about to meet other vehicles , Use low beam .

3、 Driving in the same direction at night and following closely , Use low beam .

Alternating high and low beam lamps

1、 Go through sharp turns at night 、 Slope road 、 Arch Bridge 、 Sidewalk time , Alternating use of high and low beam lamps shall not be less than 2 Time .

2、 When you pass an intersection without traffic lights at night , Alternating use of high and low beam lamps shall not be less than 2 Time .

3、 When overtaking the vehicle ahead at night , Alternating use of high and low beam lamps shall not be less than 2 Time .

remind ： Before the exam, check whether all light switches on the car are reset （ The closed position ）, After hearing the announcement of the examination system ,5 Turn on the corresponding indicator within seconds .

But anyway , No matter whether there are detailed regulations in your area , But in case of collision, the light will go out automatically , There is no problem turning on the turn signal again , Even when the car has entered the changing lane , But you can still turn on the light . What all candidates should pay attention to is , In the exam of subject three , There are many places where turn signal lamps are used , So when taking the exam after getting on the bus , Be sure to pay close attention to the situation of the direction lights , As long as the car doesn't cross the dotted line, the light goes out , Then we must turn on the light again . otherwise , The system will determine that the light is not on , Direct buckle 100 Fail . notes ： This is from the Internet , This article and I have nothing to do , If there is infringement, please contact the author to delete .